Skip to content
  1. Blog
  2. Mixing

MixingMasteringLimiterGetting started

What a limiter is: a level that is never crossed

A limiter catches anything louder than a set ceiling, instantly, so the track does not clip. How it differs from a compressor, why the ceiling goes at −1 dBTP, what true peak means, and how much limiting is too much.

Written by the site’s operator3 min read
A mastering studio
A limiter is one of the last processes a track goes through in rooms like this.Photo: Audio Mix House from United States / CC BY 2.0 / Wikimedia Commons

You play back your bounce and the loudest moment of the chorus crackles. Turning everything down fixes it, but now the whole song is quiet.

That is what a limiter is for. In one line: it instantly turns down only the peaks that would cross a level you set (the ceiling), and never lets them go above it.

Why audio clips

Digital audio has a hard upper limit: 0 dBFS. Anything above it cannot be stored, so the top of the wave is sliced flat. That slicing is what you hear as a crackle or a buzz.

A limiter sets a ceiling below that limit and turns down only the peaks that would cross it. Rather than slicing the wave, it lowers the level for a moment to fit the peak under the ceiling, which distorts far less.

Only the peaks over the ceiling are caughtCeilingOriginalAfter the limiter
Only the peaks above the ceiling are held down. Everything below it passes almost untouched.

How it differs from a compressor

Under the hood, a limiter is a kind of compressor. The difference is purpose and strength.

CompressorLimiter
PurposeNarrow the gap between loud and quietNever let a set level be crossed
RatioAround 2:1 to 6:1Very high (in effect, everything above is held down)
AttackChosen to suit the soundVery fast; many look ahead and act before the peak arrives
Where it goesOn parts or busesUsually last in the chain

Read next

Mixing

What a maximizer is: making a track louder, and why not too loud

A maximizer raises a track’s overall loudness while a limiter holds the peaks down. How it relates to a limiter, how streaming services even out volume (loudness normalisation), what −14 LUFS means, and the signs of pushing too far.

Mixing

Mastering basics: what happens after the mix

Mastering is the last step: turning a finished mix into something ready for streaming or CD. How it differs from mixing, the order of EQ, compression and limiting, streaming loudness (−14 LUFS, −1 dBTP), export formats, and how to approach a cover.

Mixing

What EQ Is: What to Cut, How Much, and Why

EQ is a volume control for each range of pitch. What you hear in the lows, mids and highs, why to start by cutting rather than boosting, what Q means, and what to try first on a vocal, with concrete frequencies.

Mixing

What a Compressor Is: Narrowing the Gap Between Loud and Quiet

A compressor turns down only what goes over a set level, evening out the volume. What threshold, ratio, attack, release and make-up gain mean, a starting point for vocals, and the signs of overdoing it.

Mixing

What reverb is: giving a voice a room to sit in

Reverb adds the reflections a room would give a sound. What pre-delay, early reflections and decay time mean, how room, hall and plate differ, why reverb goes on a send, and starting points for blending a cover vocal into a backing track.

Mixing

Where Does Harshness Live? Finding and Taming Piercing Frequencies

Most piercing sound comes from a very narrow peak somewhere around 2–5 kHz. Why hearing is so sensitive there, how to find the peak by sweeping a narrow EQ, how many spots and how much to cut, and how sibilance differs.

All articles

Sponsored links