Multi-FX-Kurzreferenz › BOSS GT-1000CORE › Regler
DEVICE LIBRARY / BOSS / VOL. 03
GT-1000COREWhat the parameters do and how they act on the sound
Was ein einzelner Regler mit dem Klang macht, Block für Block erklärt.
Alle Regler
AIRD PREAMP
Distortion
Compressor
Delay
Hall
Wah and pedal
AIRD PREAMP12 Einträge
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
Regler von AIRD PREAMP · 12
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
SAG
How much the sense of compression changes with the power amp's response, from -10 to +10. It corresponds to the supply sagging for an instant when a valve amp is hit hard.
So wird es genutztRaise it and the attack dips before it rises, for a chewy feel. Lower it to tighten up chugging.
RESO(RESONANCE)
How much the dynamics are affected by the interaction of power amp and speaker, from -10 to +10.
So wird es genutztIt changes how the low end sounds and how the amp pushes back under the fingers. Set it together with SAG.
LEVEL
The overall level of the preamp.
So wird es genutztThe official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
So wird es genutztA low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
So wird es genutztWhether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
So wird es genutztWhen the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
GAIN SW
Selects the stage of drive from LOW, MIDDLE and HIGH. Drive increases in that order.
So wird es genutztEach type is voiced around MIDDLE. Normally MIDDLE can be left as it is.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Ende der Regler von AIRD PREAMP
Distortion7 Einträge
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Regler von Distortion · 7
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
So wird es genutztDrive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
So wird es genutztWhen the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Ende der Regler von Distortion
Compressor7 Einträge
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Regler von Compressor · 7
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
So wird es genutztSet it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
So wird es genutztStrong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
So wird es genutztThe higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
DIR MIX
The level of the dry (direct) signal.
So wird es genutztCompress hard and mix in the dry signal, and the natural attack survives.
Ende der Regler von Compressor
Delay3 Einträge
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
Regler von Delay · 3
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
So wird es genutztSet to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
So wird es genutztIt gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
Ende der Regler von Delay
Hall11 Einträge
The controls of the REVERB block. Some are not shown, depending on the type.
Regler von Hall · 11
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
E.LEVEL
The level of the reverb.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
So wird es genutztWhen you want more reverb but the outline blurs, raise this and the dry signal stays in front.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
So wird es genutztWhen the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
LO DAMP
How much the low end decays, from -50 to +50.
HI DAMP
How much the top end decays, from -50 to +50.
So wird es genutztIn a real room the top end decays first. A little of this sounds natural.
MOD RATE
The speed at which the reverb is swept.
MOD DEPT(MOD DEPTH)
The depth of the sweep on the reverb.
Ende der Regler von Hall
Wah and pedal7 Einträge
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Regler von Wah and pedal · 7
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL POS
The position of the wah pedal.
So wird es genutztAn item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
E.LEVEL
The level of the effect.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
So wird es genutztFor fine control in volume swells, the SLOW settings are easier to handle.
Ende der Regler von Wah and pedal
Reglernamen und Wertebereiche folgen dem offiziellen „GT-1000CORE Parameter Guide“ von BOSS (englische Ausgabe). Die Erläuterungen und die Anwendungshinweise stammen von dieser Seite und sind keine offiziellen Übersetzungen.
Welche Regler erscheinen, hängt von Firmware und gewähltem Typ ab. Weicht dies vom Gerät ab, gilt das Gerät.