综合效果器速查表 › BOSS GT-1000CORE › 旋钮
DEVICE LIBRARY / BOSS / VOL. 03
GT-1000COREWhat the parameters do and how they act on the sound
一个旋钮如何改变声音,按模块逐一解说。
全部旋钮
AIRD PREAMP
Distortion
Compressor
延迟
混响
Wah and pedal
AIRD PREAMP12 项
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
AIRD PREAMP · 12 的旋钮
随着解说读下去,图会移近所讲的旋钮。
要到某个旋钮,可从编号列表或图中的旋钮直接跳转。
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
SAG
How much the sense of compression changes with the power amp's response, from -10 to +10. It corresponds to the supply sagging for an instant when a valve amp is hit hard.
这样用Raise it and the attack dips before it rises, for a chewy feel. Lower it to tighten up chugging.
RESO(RESONANCE)
How much the dynamics are affected by the interaction of power amp and speaker, from -10 to +10.
这样用It changes how the low end sounds and how the amp pushes back under the fingers. Set it together with SAG.
LEVEL
The overall level of the preamp.
这样用The official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
这样用A low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
这样用Whether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
这样用When the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
GAIN SW
Selects the stage of drive from LOW, MIDDLE and HIGH. Drive increases in that order.
这样用Each type is voiced around MIDDLE. Normally MIDDLE can be left as it is.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
AIRD PREAMP 的旋钮到此为止
Distortion7 项
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Distortion · 7 的旋钮
随着解说读下去,图会移近所讲的旋钮。
要到某个旋钮,可从编号列表或图中的旋钮直接跳转。
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
这样用Drive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
这样用When the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Distortion 的旋钮到此为止
Compressor7 项
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Compressor · 7 的旋钮
随着解说读下去,图会移近所讲的旋钮。
要到某个旋钮,可从编号列表或图中的旋钮直接跳转。
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
这样用Set it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
这样用Strong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
这样用The higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
DIR MIX
The level of the dry (direct) signal.
这样用Compress hard and mix in the dry signal, and the natural attack survives.
Compressor 的旋钮到此为止
延迟3 项
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
延迟 · 3 的旋钮
随着解说读下去,图会移近所讲的旋钮。
要到某个旋钮,可从编号列表或图中的旋钮直接跳转。
TIME
The delay time, set from 1ms to 2000ms or by BPM.
这样用Set to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
这样用It gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
延迟 的旋钮到此为止
混响11 项
The controls of the REVERB block. Some are not shown, depending on the type.
混响 · 11 的旋钮
随着解说读下去,图会移近所讲的旋钮。
要到某个旋钮,可从编号列表或图中的旋钮直接跳转。
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
E.LEVEL
The level of the reverb.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
这样用When you want more reverb but the outline blurs, raise this and the dry signal stays in front.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
这样用When the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
LO DAMP
How much the low end decays, from -50 to +50.
HI DAMP
How much the top end decays, from -50 to +50.
这样用In a real room the top end decays first. A little of this sounds natural.
MOD RATE
The speed at which the reverb is swept.
MOD DEPT(MOD DEPTH)
The depth of the sweep on the reverb.
混响 的旋钮到此为止
Wah and pedal7 项
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Wah and pedal · 7 的旋钮
随着解说读下去,图会移近所讲的旋钮。
要到某个旋钮,可从编号列表或图中的旋钮直接跳转。
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL POS
The position of the wah pedal.
这样用An item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
E.LEVEL
The level of the effect.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
这样用For fine control in volume swells, the SLOW settings are easier to handle.
Wah and pedal 的旋钮到此为止
旋钮名称与取值范围依据 BOSS 官方「GT-1000CORE Parameter Guide」(英文版)。解说与「这样用」为本站所写,并非官方译文。
显示哪些旋钮取决于固件与所选类型。与实机显示不一致时,以实机为准。