Guida rapida ai multieffetto › BOSS GT-1000CORE › Controlli
DEVICE LIBRARY / BOSS / VOL. 03
GT-1000COREWhat the parameters do and how they act on the sound
Che cosa fa al suono un singolo controllo, spiegato blocco per blocco.
Tutti i controlli
AIRD PREAMP
Distortion
Compressor
Delay
Riverbero
Wah and pedal
AIRD PREAMP12 voci
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
Controlli di AIRD PREAMP · 12
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
SAG
How much the sense of compression changes with the power amp's response, from -10 to +10. It corresponds to the supply sagging for an instant when a valve amp is hit hard.
Come si usaRaise it and the attack dips before it rises, for a chewy feel. Lower it to tighten up chugging.
RESO(RESONANCE)
How much the dynamics are affected by the interaction of power amp and speaker, from -10 to +10.
Come si usaIt changes how the low end sounds and how the amp pushes back under the fingers. Set it together with SAG.
LEVEL
The overall level of the preamp.
Come si usaThe official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
Come si usaA low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
Come si usaWhether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
Come si usaWhen the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
GAIN SW
Selects the stage of drive from LOW, MIDDLE and HIGH. Drive increases in that order.
Come si usaEach type is voiced around MIDDLE. Normally MIDDLE can be left as it is.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Fine dei controlli di AIRD PREAMP
Distortion7 voci
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Controlli di Distortion · 7
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
Come si usaDrive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
Come si usaWhen the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Fine dei controlli di Distortion
Compressor7 voci
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Controlli di Compressor · 7
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
Come si usaSet it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
Come si usaStrong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
Come si usaThe higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
DIR MIX
The level of the dry (direct) signal.
Come si usaCompress hard and mix in the dry signal, and the natural attack survives.
Fine dei controlli di Compressor
Delay3 voci
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
Controlli di Delay · 3
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
Come si usaSet to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Come si usaIt gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
Fine dei controlli di Delay
Riverbero11 voci
The controls of the REVERB block. Some are not shown, depending on the type.
Controlli di Riverbero · 11
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
E.LEVEL
The level of the reverb.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
Come si usaWhen you want more reverb but the outline blurs, raise this and the dry signal stays in front.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
Come si usaWhen the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
LO DAMP
How much the low end decays, from -50 to +50.
HI DAMP
How much the top end decays, from -50 to +50.
Come si usaIn a real room the top end decays first. A little of this sounds natural.
MOD RATE
The speed at which the reverb is swept.
MOD DEPT(MOD DEPTH)
The depth of the sweep on the reverb.
Fine dei controlli di Riverbero
Wah and pedal7 voci
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Controlli di Wah and pedal · 7
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL POS
The position of the wah pedal.
Come si usaAn item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
E.LEVEL
The level of the effect.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
Come si usaFor fine control in volume swells, the SLOW settings are easier to handle.
Fine dei controlli di Wah and pedal
GT-1000CORE di Elenco dei tipi →
I nomi dei controlli e le loro escursioni seguono il "GT-1000CORE Parameter Guide" ufficiale di BOSS (edizione inglese). Le spiegazioni e le note d'uso sono di questo sito, non traduzioni ufficiali.
Quali controlli compaiano dipende dal firmware e dal tipo scelto. Se qualcosa diverge dall'apparecchio, fa fede l'apparecchio.