綜合效果器速查表 › BOSS GX-100 / GX-10 › 旋鈕
DEVICE LIBRARY / BOSS / VOL. 04
GX-100 / GX-10What the parameters do and how they act on the sound
一個旋鈕如何改變聲音,依區塊逐一解說。
全部旋鈕
AIRD PREAMP
Distortion
Compressor
延遲
殘響
Wah and pedal
AIRD PREAMP12 項
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
AIRD PREAMP · 12 的旋鈕
隨著解說讀下去,圖會移近所講的旋鈕。
要到某個旋鈕,可從編號列表或圖中的旋鈕直接跳轉。
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
SAG
How much the sense of compression changes with the power amp's response, from -10 to +10. It corresponds to the supply sagging for an instant when a valve amp is hit hard.
這樣用Raise it and the attack dips before it rises, for a chewy feel. Lower it to tighten up chugging.
RESO(RESONANCE)
How much the dynamics are affected by the interaction of power amp and speaker, from -10 to +10.
這樣用It changes how the low end sounds and how the amp pushes back under the fingers. Set it together with SAG.
LEVEL
The overall level of the preamp.
這樣用The official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
這樣用A low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
這樣用Whether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
這樣用When the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
GAIN SW
Selects the stage of drive from LOW, MIDDLE and HIGH. Drive increases in that order.
這樣用Each type is voiced around MIDDLE. Normally MIDDLE can be left as it is.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
AIRD PREAMP 的旋鈕到此為止
Distortion7 項
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Distortion · 7 的旋鈕
隨著解說讀下去,圖會移近所講的旋鈕。
要到某個旋鈕,可從編號列表或圖中的旋鈕直接跳轉。
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
這樣用Drive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
這樣用When the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Distortion 的旋鈕到此為止
Compressor6 項
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Compressor · 6 的旋鈕
隨著解說讀下去,圖會移近所講的旋鈕。
要到某個旋鈕,可從編號列表或圖中的旋鈕直接跳轉。
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
這樣用Strong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
這樣用The higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
DIR MIX
The level of the dry (direct) signal.
這樣用Compress hard and mix in the dry signal, and the natural attack survives.
Compressor 的旋鈕到此為止
延遲3 項
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
延遲 · 3 的旋鈕
隨著解說讀下去,圖會移近所講的旋鈕。
要到某個旋鈕,可從編號列表或圖中的旋鈕直接跳轉。
TIME
The delay time, set from 1ms to 2000ms or by BPM.
這樣用Set to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
這樣用It gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
延遲 的旋鈕到此為止
殘響11 項
The controls of the REVERB block. Some are not shown, depending on the type.
殘響 · 11 的旋鈕
隨著解說讀下去,圖會移近所講的旋鈕。
要到某個旋鈕,可從編號列表或圖中的旋鈕直接跳轉。
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
E.LEVEL
The level of the reverb.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
這樣用When you want more reverb but the outline blurs, raise this and the dry signal stays in front.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
這樣用When the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
LO DAMP
How much the low end decays, from -50 to +50.
HI DAMP
How much the top end decays, from -50 to +50.
這樣用In a real room the top end decays first. A little of this sounds natural.
MOD RATE
The speed at which the reverb is swept.
MOD DEPT(MOD DEPTH)
The depth of the sweep on the reverb.
殘響 的旋鈕到此為止
Wah and pedal7 項
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Wah and pedal · 7 的旋鈕
隨著解說讀下去,圖會移近所講的旋鈕。
要到某個旋鈕,可從編號列表或圖中的旋鈕直接跳轉。
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL POS
The position of the wah pedal.
這樣用An item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
E.LEVEL
The level of the effect.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
這樣用For fine control in volume swells, the SLOW settings are easier to handle.
Wah and pedal 的旋鈕到此為止
參數名稱依據 BOSS 官方「GX-100 Parameter Guide」(英文版)。與 GT-1000CORE 共通的參數,僅列出 GX-100 指南中有記載者。解說與「這樣用」為本站所寫,並非官方譯文。
數值範圍與顯示會隨韌體及所選類型改變。與實機顯示不一致時,以實機為準。