멀티이펙터 조견표 › BOSS GX-100 / GX-10 › 노브
DEVICE LIBRARY / BOSS / VOL. 04
GX-100 / GX-10What the parameters do and how they act on the sound
노브 하나가 소리를 어떻게 바꾸는가. 블록마다 해설한다.
모든 노브
AIRD PREAMP
Distortion
Compressor
딜레이
리버브
Wah and pedal
AIRD PREAMP12항목
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
AIRD PREAMP · 12의 노브
해설을 읽어 나가면 그림이 그 노브로 다가간다.
원하는 노브로는 번호 목록이나 그림 속 노브에서 바로 이동할 수 있다.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
SAG
How much the sense of compression changes with the power amp's response, from -10 to +10. It corresponds to the supply sagging for an instant when a valve amp is hit hard.
이렇게 쓴다Raise it and the attack dips before it rises, for a chewy feel. Lower it to tighten up chugging.
RESO(RESONANCE)
How much the dynamics are affected by the interaction of power amp and speaker, from -10 to +10.
이렇게 쓴다It changes how the low end sounds and how the amp pushes back under the fingers. Set it together with SAG.
LEVEL
The overall level of the preamp.
이렇게 쓴다The official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
이렇게 쓴다A low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
이렇게 쓴다Whether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
이렇게 쓴다When the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
GAIN SW
Selects the stage of drive from LOW, MIDDLE and HIGH. Drive increases in that order.
이렇게 쓴다Each type is voiced around MIDDLE. Normally MIDDLE can be left as it is.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
AIRD PREAMP의 노브는 이상
Distortion7항목
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Distortion · 7의 노브
해설을 읽어 나가면 그림이 그 노브로 다가간다.
원하는 노브로는 번호 목록이나 그림 속 노브에서 바로 이동할 수 있다.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
이렇게 쓴다Drive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
이렇게 쓴다When the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
SOLO SW
Switches to a tone for solos.
SOLO LVL(SOLO LEVEL)
The level when SOLO SW is on.
Distortion의 노브는 이상
Compressor6항목
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Compressor · 6의 노브
해설을 읽어 나가면 그림이 그 노브로 다가간다.
원하는 노브로는 번호 목록이나 그림 속 노브에서 바로 이동할 수 있다.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
이렇게 쓴다Strong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
이렇게 쓴다The higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
DIR MIX
The level of the dry (direct) signal.
이렇게 쓴다Compress hard and mix in the dry signal, and the natural attack survives.
Compressor의 노브는 이상
딜레이3항목
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
딜레이 · 3의 노브
해설을 읽어 나가면 그림이 그 노브로 다가간다.
원하는 노브로는 번호 목록이나 그림 속 노브에서 바로 이동할 수 있다.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
이렇게 쓴다Set to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
이렇게 쓴다It gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
딜레이의 노브는 이상
리버브11항목
The controls of the REVERB block. Some are not shown, depending on the type.
리버브 · 11의 노브
해설을 읽어 나가면 그림이 그 노브로 다가간다.
원하는 노브로는 번호 목록이나 그림 속 노브에서 바로 이동할 수 있다.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
E.LEVEL
The level of the reverb.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
이렇게 쓴다When you want more reverb but the outline blurs, raise this and the dry signal stays in front.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
이렇게 쓴다When the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
LO DAMP
How much the low end decays, from -50 to +50.
HI DAMP
How much the top end decays, from -50 to +50.
이렇게 쓴다In a real room the top end decays first. A little of this sounds natural.
MOD RATE
The speed at which the reverb is swept.
MOD DEPT(MOD DEPTH)
The depth of the sweep on the reverb.
리버브의 노브는 이상
Wah and pedal7항목
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Wah and pedal · 7의 노브
해설을 읽어 나가면 그림이 그 노브로 다가간다.
원하는 노브로는 번호 목록이나 그림 속 노브에서 바로 이동할 수 있다.
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL POS
The position of the wah pedal.
이렇게 쓴다An item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
E.LEVEL
The level of the effect.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
이렇게 쓴다For fine control in volume swells, the SLOW settings are easier to handle.
Wah and pedal의 노브는 이상
파라미터의 명칭은 BOSS 공식 「GX-100 Parameter Guide」(영문판)에 따른다. GT-1000CORE와 공통인 파라미터 중 GX-100 가이드에 기재된 것만 실었다. 해설과 「이렇게 쓴다」는 본 사이트의 것이며 공식 번역이 아니다.
값의 범위나 표시는 펌웨어와 선택한 타입에 따라 달라진다. 실기 표시와 다를 경우 실기를 기준으로 한다.