Guia rápido de FX 日本語

Guia rápido de multiefeitos › Line 6 HX Stomp › Controles

DEVICE LIBRARY / Line 6 / VOL. 01

HX StompWhat the parameters do and how they act on the sound

O que um único controle faz com o som, explicado bloco a bloco.

41 CONTROLS6 CATEGORIESConforme Ver.3.80 ↗
06B1Seismic MattersTwinHarmonyAdriaticDelayTAP/TUNER⌂ VIEWACTIONSAVE◀ PAGEPAGE ▶≡VOLUMELINE 6HX STOMPLine 6 HX Stomp

Explore published presets & tone settings ↗

Amplificadores12 itens

The controls of the Amp, Amp+Cab and Preamp blocks. Bass, Mid, Treble and the row above recreate the circuits of the real amps, so how they act and how they interact differ from model to model. From Master down, they are common to every amp model.

MFGVIRTUAL AMP · A-12CH VOL01010DRIVE02010BASS03010MID04010TREBLE05010PRESENCE06010MASTER07010SAG08010HUM09010RIPPLE10010BIAS11010BIAS X12010INPUTPOWER

Controles de Amplificadores · 12

À medida que você lê, o desenho se aproxima do controle descrito.

Vá direto a um controle pela lista numerada ou pelo botão no desenho.

  1. Ch Vol

    Raises or lowers the level alone, without changing the tone. It does not affect the drive.

    Como usarUsed once the tone is set, to match levels between presets. It corresponds to a fader on a mixer.

  2. Drive

    How much is sent into the preamp. The higher, the more drive. On amps with a master volume it acts as gain; on amps without one it is the real amp's volume control itself.

  3. Bass

    The amount of low end. The real circuit is recreated, so on some models the midrange and the drive move with it.

    Como usarA low end that feels good playing alone is almost certainly too much in a band. It is the band closest to the bass, so think in terms of taking it away and the parts fit together.

  4. Mid

    The amount of midrange. Whether the guitar cuts through a band is decided almost entirely here.

    Como usarLower it and the tone scoops. It sounds good alone, but it is behind most cases of a guitar disappearing in a recording.

  5. Treble

    The amount of top end. Raise it for outline and cut. Too far and it stings.

    Como usarOn models with a control the real amp does not have, starting at twelve o'clock (50%) is the honest approach.

  6. Presence

    The tension of the top end at the power amp. It acts above the band of the tone stack's Treble.

    Como usarWhen the guitar will not cut and raising Treble makes it sting, raise this instead: it comes forward without the sting.

  7. Master

    How hard the power amp is pushed. The higher, the more power-valve drive. With this low, Sag, Bias and Bias X all weaken together.

    Como usarOn models of amps without a master volume, 100% is the norm. If moving the controls below has little effect, first check whether Master is too low.

  8. Sag

    The time a valve takes to return to full power after a heavy load. Also called compression or squash, it puts a dip into the attack.

    Como usarRaise it on small tweed amps when you want depth and chew. In country or metal, where fast picking and chord work run on, it blurs the sound, so lower it and tighten up.

  9. Hum

    How much hum leaking from the preamp valve heaters is mixed into the signal. Less a tone control than the rawness and grit of a real amp. Over drive it adds instability.

    Como usarThere is no control for this on the real amp and no right answer. Starting around twelve o'clock (50%) and following your ear is the safe approach.

  10. Ripple

    How much ripple left over from the power supply's rectification is mixed into the signal. With Hum, it sets how worn the amp feels.

    Como usarAs with Hum, there is no matching control on the real amp. Raise it and the drive wavers and turns unstable.

  11. Bias

    The output valve bias. Properly it sets the valves to their best operating point, but it serves tone as well. Higher (hotter) is warmer, softer and easier to drive; lower (colder) has more punch and more headroom.

    Como usarFor hard and tight, go colder; for warm and easily driven, go hotter. If crossover distortion bothers you, raising it to around 6–8 settles it.

  12. Bias X

    The amount of bias excursion — the bias shifting momentarily — in the output stage at high volume and high input. The larger the shift, the more it is heard as crossover distortion.

    Como usarRaise it and crossover distortion appears more readily, with a stronger sense of valves collapsing. It is bound up with Drive and Master, so set it together with them rather than alone. The Line 6 article notes that most players need not concern themselves with this control.

Fim dos controles de Amplificadores

HX Stomp de Lista de modelos →

Foram consultados o "HX Stomp Manual" da Line 6, o artigo da Line 6 Japan (Dave Hunter, "Uso dos ajustes Sag, Bias e Bias Excursion") e a comunidade Helix Help . O texto é próprio deste site, não uma declaração nem uma tradução oficial.

Os controles aparecem e desaparecem conforme o firmware e o modelo. Se isto divergir do aparelho, vale o aparelho.

Atualizado

Line 6 e HX Stomp são marcas da Line 6 / Yamaha Guitar Group. Os nomes dos produtos modelados são marcas de seus respectivos titulares, nenhum dos quais tem relação com este site.

Unofficial reference · Not affiliated with Line 6