Guia rápido de multiefeitos › BOSS GX-1 › Controles
DEVICE LIBRARY / BOSS / VOL. 05
GX-1What the parameters do and how they act on the sound
O que um único controle faz com o som, explicado bloco a bloco.
Todos os controles
AMP
Distortion
Compressor
Delay
Reverb
Wah and pedal
AMP5 itens
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
Controles de AMP · 5
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
LEVEL
The overall level of the preamp.
Como usarThe official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
Como usarA low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
Como usarWhether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
Fim dos controles de AMP
Distortion4 itens
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Controles de Distortion · 4
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
Como usarDrive raises the level too. Match it here so there is no jump when you step on it.
DIR MIX
The level of the dry (direct) signal.
Como usarWhen the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
Fim dos controles de Distortion
Compressor5 itens
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Controles de Compressor · 5
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
Como usarSet it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
Como usarStrong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
RATIO
The compression ratio, from 1:1 to INF:1.
Como usarThe higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
Fim dos controles de Compressor
Delay3 itens
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
Controles de Delay · 3
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
Como usarSet to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Como usarIt gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
Fim dos controles de Delay
Reverb5 itens
The controls of the REVERB block. Some are not shown, depending on the type.
Controles de Reverb · 5
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
Como usarWhen you want more reverb but the outline blurs, raise this and the dry signal stays in front.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Fim dos controles de Reverb
Wah and pedal5 itens
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Controles de Wah and pedal · 5
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
Como usarFor fine control in volume swells, the SLOW settings are easier to handle.
Fim dos controles de Wah and pedal
Os nomes dos parâmetros seguem o "GX-1 Parameter Guide" oficial da BOSS (em inglês). Dos parâmetros comuns ao GT-1000CORE, constam apenas os documentados no guia do GX-1. O amplificador do GX-1 tem apenas GAIN, BASS, MIDDLE, TREBLE e LEVEL, sem SAG e afins. As explicações e as notas de uso são próprias deste site, não traduções oficiais.
As faixas de valores e o que aparece no visor dependem do firmware e do tipo escolhido. Se isto divergir do aparelho, vale o aparelho.