Guida rapida ai multieffetto › BOSS GX-1 › Controlli
DEVICE LIBRARY / BOSS / VOL. 05
GX-1What the parameters do and how they act on the sound
Che cosa fa al suono un singolo controllo, spiegato blocco per blocco.
Tutti i controlli
AMP
Distortion
Compressor
Delay
Riverbero
Wah and pedal
AMP5 voci
AIRD PREAMP is BOSS's own method, recreating the whole amp down to the response of the circuit and the way its parts act on each other. How the controls behave changes with the type.
Controlli di AMP · 5
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
LEVEL
The overall level of the preamp.
Come si usaThe official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
Come si usaA low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
Come si usaWhether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
Fine dei controlli di AMP
Distortion4 voci
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Controlli di Distortion · 4
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
Come si usaDrive raises the level too. Match it here so there is no jump when you step on it.
DIR MIX
The level of the dry (direct) signal.
Come si usaWhen the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
Fine dei controlli di Distortion
Compressor5 voci
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Controlli di Compressor · 5
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
Come si usaSet it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
Come si usaStrong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
RATIO
The compression ratio, from 1:1 to INF:1.
Come si usaThe higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
Fine dei controlli di Compressor
Delay3 voci
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
Controlli di Delay · 3
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
Come si usaSet to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Come si usaIt gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
Fine dei controlli di Delay
Riverbero5 voci
The controls of the REVERB block. Some are not shown, depending on the type.
Controlli di Riverbero · 5
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
TONE
The tone of the reverb, from -50 to +50.
DENSITY
The density of the tail, from 1 to 10.
PRE-DELY(PRE-DELAY)
The time before the reverb begins, from 0 to 200ms.
Come si usaWhen you want more reverb but the outline blurs, raise this and the dry signal stays in front.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Fine dei controlli di Riverbero
Wah and pedal5 voci
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Controlli di Wah and pedal · 5
Man mano che leggi, il disegno si avvicina al controllo descritto.
Vai direttamente a un controllo dall'elenco numerato o dalla manopola nel disegno.
WAH TYPE
Selects the kind of wah: CRY WAH (CRY BABY), VO WAH (VOX V846) and others.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
DIR MIX
The level of the dry (direct) signal.
CURVE(FOOT VOLUME)
Selects how the level follows the pedal: SLOW1, SLOW2, NORMAL or FAST.
Come si usaFor fine control in volume swells, the SLOW settings are easier to handle.
Fine dei controlli di Wah and pedal
I nomi dei parametri seguono il "GX-1 Parameter Guide" ufficiale di BOSS (edizione inglese). Dei parametri comuni al GT-1000CORE sono riportati solo quelli documentati nella guida del GX-1. L'amplificatore del GX-1 ha soltanto GAIN, BASS, MIDDLE, TREBLE e LEVEL, senza SAG e simili. Le spiegazioni e le note d'uso sono di questo sito, non traduzioni ufficiali.
Escursioni e indicazioni a display dipendono dal firmware e dal tipo scelto. Se qualcosa diverge dall'apparecchio, fa fede l'apparecchio.