Multi-FX-Kurzreferenz › BOSS GT-1 › Regler
DEVICE LIBRARY / BOSS / VOL. 06
GT-1What the parameters do and how they act on the sound
Was ein einzelner Regler mit dem Klang macht, Block für Block erklärt.
Alle Regler
PREAMP
Distortion
Compressor
Delay
Hall
Wah and pedal
PREAMP7 Einträge
GT-1はCOSM-modelingのアンプタイプを模型として再現します。GAINなどのプリ・アンプ項目は選択中のCOSMモデルに作用します。GT-1にAIRD PREAMPのSAGやRESONANCEの項目はありません。
Regler von PREAMP · 7
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
LEVEL
The overall level of the preamp.
So wird es genutztThe official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
So wird es genutztA low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
So wird es genutztWhether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
So wird es genutztWhen the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
Ende der Regler von PREAMP
Distortion5 Einträge
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Regler von Distortion · 5
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
So wird es genutztDrive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
So wird es genutztWhen the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
Ende der Regler von Distortion
Compressor6 Einträge
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Regler von Compressor · 6
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
So wird es genutztSet it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
So wird es genutztStrong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
So wird es genutztThe higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
Ende der Regler von Compressor
Delay3 Einträge
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
Regler von Delay · 3
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
So wird es genutztSet to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
So wird es genutztIt gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
Ende der Regler von Delay
Hall4 Einträge
The controls of the REVERB block. Some are not shown, depending on the type.
Regler von Hall · 4
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
E.LEVEL
The level of the reverb.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
So wird es genutztWhen the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Ende der Regler von Hall
Wah and pedal3 Einträge
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Regler von Wah and pedal · 3
Beim Weiterlesen rückt die Zeichnung an den beschriebenen Regler heran.
Zu einem Regler gelangst du direkt über die nummerierte Liste oder über den Knopf in der Zeichnung.
PDL POS
The position of the wah pedal.
So wird es genutztAn item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
Ende der Regler von Wah and pedal
Die Parameternamen folgen dem offiziellen „GT-1 Parameter Guide“ von BOSS (englische Ausgabe). Von den mit dem GT-1000CORE gemeinsamen Parametern sind nur die im GT-1-Guide dokumentierten aufgeführt. Die Vorstufe des GT-1 hat weder SAG noch RESONANCE. Die Erläuterungen und die Anwendungshinweise stammen von dieser Seite und sind keine offiziellen Übersetzungen.
Wertebereiche und Anzeige hängen von Firmware und gewähltem Typ ab. Weicht dies vom Gerät ab, gilt das Gerät.