Guia rápido de multiefeitos › BOSS GT-1 › Controles
DEVICE LIBRARY / BOSS / VOL. 06
GT-1What the parameters do and how they act on the sound
O que um único controle faz com o som, explicado bloco a bloco.
Todos os controles
PREAMP
Distortion
Compressor
Delay
Reverb
Wah and pedal
PREAMP7 itens
GT-1はCOSM-modelingのアンプタイプを模型として再現します。GAINなどのプリ・アンプ項目は選択中のCOSMモデルに作用します。GT-1にAIRD PREAMPのSAGやRESONANCEの項目はありません。
Controles de PREAMP · 7
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
GAIN
The amount of amp drive, from 0 to 120. The higher, the more drive.
LEVEL
The overall level of the preamp.
Como usarThe official guide warns against raising it too far. It causes clipping further down the chain.
BASS
The low tone control, from 0 to 100.
Como usarA low end that feels good playing alone is almost certainly too much in a band.
MIDDLE
The mid tone control, from 0 to 100.
Como usarWhether the guitar cuts through a band is decided almost entirely here.
TREBLE
The high tone control, from 0 to 100.
PRESENCE
The tone above that, in the extreme top, from 0 to 100.
Como usarWhen the guitar will not cut and raising TREBLE makes it sting, raise this instead: it comes forward without the sting.
BRIGHT
Bright on or off. It is not shown on some types.
Fim dos controles de PREAMP
Distortion5 itens
The controls of the DISTORTION 1 and 2 blocks. From boosters to fuzz, the layout is the same for every type.
Controles de Distortion · 5
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
DRIVE
The depth of drive, from 0 to 120.
TONE
The tone, from -50 to +50.
LEVEL
The level of the effect.
Como usarDrive raises the level too. Match it here so there is no jump when you step on it.
BOTTOM
The low tone control, from -50 to +50. To the left the low end is trimmed, to the right it is lifted.
DIR MIX
The level of the dry (direct) signal.
Como usarWhen the low end collapses on fuzz or metal types, mixing in a little dry signal brings the core back.
Fim dos controles de Distortion
Compressor6 itens
The controls of the COMPRESSOR block. Some are not shown, depending on the type.
Controles de Compressor · 6
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
THRESHLD(THRESHOLD)
The level at which compression begins. Above it, the signal is compressed. Shown only on the X-BASS type.
Como usarSet it to suit the input signal.
SUSTAIN
The range (the time) over which quiet signals are lifted. The larger it is, the longer the sustain. Not shown on the X-BASS type.
ATTACK
The strength of the attack when the strings are picked.
Como usarStrong gives a popping grain; gentle blends in naturally.
LEVEL
The level.
TONE
The tone, from -50 to +50.
RATIO
The compression ratio, from 1:1 to INF:1.
Como usarThe higher the ratio the stronger the compression; at INF:1 it behaves much like a limiter.
Fim dos controles de Compressor
Delay3 itens
Parameters common to the DELAY 1–4 blocks. Not shown on the TWIST type.
Controles de Delay · 3
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
TIME
The delay time, set from 1ms to 2000ms or by BPM.
Como usarSet to BPM it follows each patch's MASTER BPM automatically. Choose this to lock to the tempo. Where the length would exceed the range, it syncs to a half or a quarter of the cycle.
FEEDBACK
How much of the delayed signal returns to the input. The larger it is, the more repeats.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Como usarIt gives the texture of a tape echo, the top end falling away with every repeat. It also helps a delay stay out of the way of the dry signal.
Fim dos controles de Delay
Reverb4 itens
The controls of the REVERB block. Some are not shown, depending on the type.
Controles de Reverb · 4
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
TIME
The length of the tail, from 0.1 to 10.0 seconds.
E.LEVEL
The level of the reverb.
LO CUT
The frequency at which the low end begins to be trimmed. At FLAT nothing is trimmed.
Como usarWhen the tail turns muddy, trimming the low end first tidies it up.
HI CUT
The frequency at which the top end begins to be trimmed. At FLAT nothing is trimmed.
Fim dos controles de Reverb
Wah and pedal3 itens
The controls of WAH and the pedal effects. Some are meant to be assigned to a pedal.
Controles de Wah and pedal · 3
À medida que você lê, o desenho se aproxima do controle descrito.
Vá direto a um controle pela lista numerada ou pelo botão no desenho.
PDL POS
The position of the wah pedal.
Como usarAn item meant to be assigned to an expression pedal or the like.
PDL MIN
The tone with the pedal fully back on the heel.
PDL MAX
The tone with the pedal fully down on the toe.
Fim dos controles de Wah and pedal
Os nomes dos parâmetros seguem o "GT-1 Parameter Guide" oficial da BOSS (em inglês). Dos parâmetros comuns ao GT-1000CORE, constam apenas os documentados no guia do GT-1. O pré-amplificador do GT-1 não tem SAG nem RESONANCE. As explicações e as notas de uso são próprias deste site, não traduções oficiais.
As faixas de valores e o que aparece no visor dependem do firmware e do tipo escolhido. Se isto divergir do aparelho, vale o aparelho.